arcnet diagnosing software for noritsu 3202

The laser temperature R is adjustable from 31.5 ° C to 32.5 ° C once (standby state), and if the temperature exceeds 35.0 ° C (upper-temperature limit), error 6107-0001 is generated. The R-laser temperature is monitored from 34.5 ° C to 35.5 ° C once (standby state), and if the temperature exceeds 38.0 ° C (high-temperature limit), error 6107-0001 is generated. QSS 30 series (for version E or earlier):

The laser control board is not associated with R-laser temperature reading. With this digital value, the temperature is displayed by the software. On the laser I / O PCB, the sensor resistance is converted to a supply voltage, and then it is converted to a digital value in the AC converter on the printer control board. The R-laser temperature measurement is performed in the following order: sensor, laser I / O PCB, and printer control PCB. Recommendation: First of all, check the temperature of the R-laser in the Adjust the laser unit (Service menu). It is useless to try to fix it on your own. QSS 32 and later with A1 or fF type – you can try to “reset” the laser.Įven if it helps for a while, in the end, you will still have to repair the laser module. QSS 30/31 with Type A laser – you can auto-tune. We recommend that you send us the defective laser module for upgrading to the SLD level or get a new SLD laser module. Using a laser at this level will very quickly shorten the life of the laser as it destroys all the internal elements of the laser module. Sometimes this can be erased by restarting the lab and the lab will run without any errors for a certain amount of time, but the appearance of this error means that a certain laser module is operating at a current that is VERY close to the maximum allowable limit. When such errors appear, first take corrective actions for each error.

This error message can appear due to the following errors This error can occur if the current has reached the maximum limit. The code of the most serious and unpleasant error for the laboratory owner.

Arcnet diagnosing software for noritsu 3202